Product introduction
The dust test chamber is called “sand and dust test chamber”, which simulates the destructive nature of the sand climate to the product and is suitable for detecting the shell sealing performance of the product. It is mainly used for the test of IP5X and IP6X as specified in the enclosure protection level standard.
Specifications
|
Model |
ZH—SC—500—C |
ZH—SC—1000—C |
ZH—SC—1500—C |
|
Inner dia（mm） |
800*800*800 |
1000*1000*1000 |
1000*1000*1500 |
|
Classification |
talcum powder |
||
|
Time of duration |
2 or 8 hours |
||
|
Test temp. |
RT~70℃ |
||
|
Test hum. |
45%-75%RH |
||
|
Nominal wire diameter of metal screen |
50μm |
||
|
Nominal spacing between lines |
75μm |
||
|
Wind speed |
≥2m/s |
||
|
Dust Concentration |
2~4Kg/m3 |
||
|
Dust requirements |
Meet JIS6 requirements (or corresponding national standards) |
||
|
Oscillator period |
0-99H99M99S |
||
|
Dust setting |
Continuous and periodic dust blowing can be selected at any time |
||
|
Shell material |
High-quality cold-rolled steel plate electrostatic spray |
||
|
Inner material |
SUB304 High quality stainless steel precision welding |
||
|
Thermal insulation material |
Superfine glass fiber cotton |
||
|
Safety protection |
Over temperature and over limit alarm protection, power leakage, short circuit, phase loss protection,under voltage protection |
||
|
Power supply |
AC220/380V±10%，1PH，50/60HZ |
||
|
Standard devices |
Vacuum pump, gas flow meter, gas source interface, pressure gauge, oil-water separator |
||
|
Remark |
1. Can be customized according to customer needs 2. Specific parameters and specifications are subject to the quotation |
||
